Wireless Water Leak Detector
Battery powered, so it goes wherever the plumbing is - no wires back to the hub.
Water damage is slow, quiet and expensive - and the expense is rarely the water. A leak that runs unnoticed grows mold in the framing, and mold is not something you clean up: it means tearing out the wood it has reached, replacing it, and hoping it did not travel further than you can see. The trouble is that the places it starts are exactly the places that are awkward to wire: the back of a sink cabinet, behind the water heater, down beside the pump. This detector runs on a battery and reports to your Off-Grid Guardian hub wirelessly, so you can put one wherever a leak would actually begin without running cable through the cabin or rig to get there. It draws almost nothing, so it sits and waits for a long time between battery changes. Most people want more than one - under the sink, by the hot water heater, and next to the freshwater pump is the usual set.
-
Put it where the leak starts
Under the sink, behind the water heater, beside the freshwater pump. No wire has to reach it, so the awkward spots stop being awkward.
-
Buy a few
One detector covers one spot. Three of them cover the three places that actually fail in most rigs, and they all report to the same hub.
-
Catch it before the mold
By the time a stain shows on the floor, the subfloor underneath has usually been wet for weeks and the mold is already in it. Replacing framing costs far more than drying a floor - you get a message the moment it is wet, while that is still all it is.
- Wireless water leak detector
- Battery